Questions on what a camera can do or its specifications. Do not post here for problems using the cameras or software.

Powering a BFLY-U3-23S6M-C camera via the GPIO pin 1 Answered
0 votes 3 comments
Powering a BFLY-U3-23S6M-C camera via the GPIO pin 1 Answered
0 votes 1 comment
Can blackfly camera operate at -20C? Answered
0 votes 1 comment
Getting blackfly cameras to work with WLS2 Answered
0 votes 1 comment
BFS-U3-19S4M-C Answered
0 votes 2 comments
RAM on BFS-PGE-31S4M-C. Answered
0 votes 4 comments
Camera spectral sensitivity Answered
0 votes 1 comment
Minimum ExposureTime increases with trigger enabled Answered
0 votes 1 comment
CM3-U3-13Y3M-CS Photon Integration Cycle Answered
0 votes 3 comments
Decrease frame rate on Chameleon3 Answered
0 votes 3 comments
FLIR BFS-U3-16S2C-CS fps reduced Answered
0 votes 1 comment
Why does my camera have a 10bit bit depth? Answered
0 votes 1 comment
FPS in HW trigger mode Answered
0 votes 3 comments
Calculation of maximum FPS rate with an external trigger Answered
0 votes 3 comments
Serial Port on opto-isolated input/output pins? Answered
0 votes 3 comments
Frame rate in HW trigger mode Answered
0 votes 2 comments
Read GPIO / synchronize to external device Answered
0 votes 3 comments
Camera Frame rate in different trigger modes Answered
0 votes 3 comments
below 0°C? Answered
0 votes 1 comment
Laser damage? Answered
0 votes 1 comment
Can your cameras be used in a vacuum? e.g. in space? Answered
0 votes 1 comment
Are your cameras FCC class A or B? Answered
0 votes 2 comments
I am looking for a deep learning camera. Do you have any? Answered
0 votes 1 comment
bfs u3 vs Forge Answered
0 votes 1 comment
Which BFS camera should I get? Answered
0 votes 1 comment
My camera runs hot Answered
0 votes 1 comment
what camera works best for low light? Answered
0 votes 1 comment
What kind of vibration testing is done on a BFS-U3-200S6C-C? Answered
0 votes 1 comment
Where can I find the GPIO electrical characteristics to trigger the camera? Answered
0 votes 1 comment
Do you have any camera for infrared imaging? Answered
0 votes 1 comment