Varun Narasimhan
- Total activity 24
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 6
Comments
Recent activity by Varun Narasimhan-
hello Demos, thanks for that. I tried doing those things and updating all the firmwares with the same file but it still wouldn't work on my 3rd party software the way it works for the other cameras...
-
Hi Demos, Thank you for this. I have had some preliminary successes in trials of 3 cameras by using a lower trigger rate. I plan to try and increase the number of cameras to help me do this some mo...
-
Hi Demos Thank you for that. I have used different resistors to enable a higher voltage drop and and the cameras are getting triggered best I can tell. However, their recordings are not synced up. ...
-
Thank you again. For the CM3-U3-31S4C-CS cameras, what is the required voltage output through the pins from the arduino into the GPIO cables? While triggering the cameras, I don't want to give it a...
-
Hi Ifeanyi, Thank you for this. Is there a way to get it so that it is outputted through the ~6 point on the Arduino Uno? Also is it possible to control the frequency and duration of each square pu...
-
OK I will do that. Thank you.
-
Thanks. But updating the firmware did not seem to help. And also I tried changing the exposure time but that setting is locked.
-
Hi Manuel, I am using Spinnaker right now anyway. I would prefer to stick with that. Also I don't think I actually downloaded the firmware the first time. I have downloaded it now and I have also d...
-
Hi Manuel, I have actually managed to get the trigger working apparently. Now at least when I turn the trigger mode to off on the primary camera, both primary and secondary cameras start recording....
-
Hi, Is there any other suggestions that you have? I tried to connect the green and black pins but I noticed no difference. Only the primary camera seems to record images and I want both of them to...