TDY_Kevin
Community team- Total activity 43
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 22
Activity overview
Latest activity by TDY_Kevin-
TDY_Kevin commented,
The default gateway and IP address should not be the same. Here’s a brief explanation: IP Address: This is a unique address assigned to each device on a network, allowing it to communicate with ot...
-
TDY_Kevin created a post,
Could not read the XML URL [-1010]
AnsweredWe're currently facing an error in one of them where the IP gets randomly misconfigured mainly after the equipment has been without use for a couple of hours. The IP for both the camera and th...
-
TDY_Kevin commented,
Unfortunately, we only support Ubuntu LTS versions officially. You might be able to get our SDK work on other Linux distributions, but this is beyond our support scope. Kind Regards, Kevin
-
TDY_Kevin commented,
Hi Clinton, You can check in SpinView > Acquisition Control > Exposure Time > right click and select "Display Node Information" to get the Min and Max of the Exposure Time that you can set on your ...
-
TDY_Kevin commented,
Let me explain a bit further in details: - the actual timestamp that gets stored, whether at the beginning of the Exposure (free run mode) or at the end of the Exposure (trigger mode) will ALWAYS b...
-
TDY_Kevin commented,
First of all, please take a look of our KB Using PPS to Synchronize with External GPS | Teledyne FLIR "Timestamp The LadybugImageInfo contains the timestamp and shutter time information. In trigger...
-
TDY_Kevin created a post,
LD5P and PPS synchronization
AnsweredI am curious about when a Ladybug Image is completed (in milliseconds).Regardless of Gain, Shutter, illumination environment, illumination change, etc., is the time when the image is completed is ...
-
TDY_Kevin created a post,
Ladybug SDK xcopy compile error
AnsweredRecently there seem to be a compilation error related to xcopy when trying to compile the examples in Ladybug SDK. The exact error look like this: After checking the output, it seems the cause of ...
-
TDY_Kevin commented,
Official comment To update your Flea3 USB3 camera from 1.x to 2.x firmware, you will have to update its firmware to version 2.07.3-01 first. https://flir.box.com/s/b9f55ugkfe33ypx02ibzaz6zcre8wchu
-
TDY_Kevin commented,
Official comment Ladybug2:diagonal 153.9 vertical 115.5 horizontal 83.8 Ladybug3:Aperture: F2.5Roughly 75x100 degrees. It is rough because the lens has high distortion.The angle of view of one sensor should be clos...