TDY_Manuel
Community team- Total activity 243
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 6
- Subscriptions 99
Activity overview
Latest activity by TDY_Manuel-
TDY_Manuel commented,
Glad to hear you figured it out. You are right, hitting the play button starts the cameras image acquisition and transfer, but since it is in trigger mode it will sit and wait for the trigger signa...
-
TDY_Manuel commented,
Hi Minsung, From your description, I think you should set Trigger Activation to rising or falling edge. Does that change anything? If that doesn't help, do you have a scope to measure your trigger ...
-
TDY_Manuel commented,
Hi MJ, I think this article might answer your question: https://www.teledynevisionsolutions.com/support/support-center/technical-guidance/iis/how-is-gamma-calculated-and-applied/Best regards, Manuel
-
TDY_Manuel commented,
Official comment Hello Philip, I'm afraid this forum deals with Teledyne Flir IIS machine vision, spherical and stereo cameras only. You can find tech support for the FLIR Duo here: https://flir.custhelp.com/app/...
-
TDY_Manuel commented,
Hi Emre, in your code you don't seem to call configure_trigger, which is where the code resided that you posted, but some other function. Is that a mistake? Best regards, Manuel
-
TDY_Manuel commented,
Official comment We saw in the support ticket that Spinnaker can detect the camera when run as sudo. Our software team will look into this.
-
TDY_Manuel commented,
Do you mean the camera starts to capture images when you call BeginAcquisition before it has been triggered? I can not spot anything obvious. Have you tried running your code to configure the camer...
-
TDY_Manuel commented,
Hello Emre, You should set AcquisitionMode to Continuous. Otherwise you have to start the camera for every frame. If the camera starts with the first trigger pulse and then keeps running, it sounds...
-
TDY_Manuel commented,
Official comment Could you please try again with a higher brightness setting to prevent the lower part of the histogram from being cut off? Also, please make sure gamma is turned off. Best use a RAW pixel format. ...
-
TDY_Manuel commented,
Official comment This can be fixed by making sure the network controllers are in separate subnets. E.g. change the addresses of the NICs the cameras are connected to to [192.168.0.1/24] and [192.168.1.1/24]